Thông số kỹ thuật K-ARRAY TURTLE-KRM33
ACOUSTICS | |
Power handling | 180W (AES) |
Frequency range | 70 Hz – 18 KHz +/- 3dB 100 Hz – 18 KHz +/- 3dB |
SPL 1W/1mt | 93 db |
Maximum SPL | 115dB (cont) – 121dB (peak) |
COVERAGE | |
Horizontal | DSP controlled (30° / 70° selectable) |
Vertical | 90° |
CROSSOVER | |
Type | DSP controlled |
Frequency | 70 Hz minimum (preset dependent) |
TRANSDUCERS | |
Type | 3 X 3,15” Neodymiun cone driver with 1” voice coil |
Type | 1 X 6” passive radiator |
SELECTION SWITCH | |
Horizontal pattern | Spot – Flood |
Response | Bass Enhancer |
AUDIO INPUT | |
Analog connector | 1 male + 1 female 3-pin balanced XLR |
REMOTE CONTROL INPUT | |
Connector | 1 USB type B |
POWER INPUT | |
Connector | 2 x PowerCon IN/OUT |
AMPLIFIER | |
Type | 1 module class D – DSP controlled |
Nominal power output | 2 X 125 W @ 4 Ω 1% THD + NOISE |
Protection | Dynamic limiter – Over current – Short circuit |
Frequency response | 20 Hz – 20 KHz, all load +/- 0.5 dB |
Damping factor 8Ω, 100Hz | > 500 |
THD+N 1KHz, 1 W | 0.003% |
AC POWER | |
Nominal voltage | 115 / 230 Vac auto switching |
Operating range | 85 – 132 Vac 170 – 264 Vac 50 – 60 Hz |
I. Nom | 2 A / 115 Vac 1 A / 230 Vac |
CONSUMPTION | 85 – 265 Vac |
Quiescent power (with no signal in) | 10 W |
1/8 rated power (pink noise) @ 4 Ω | 110 W |
Peak power | 660 W / 120 ms |
CERTIFICATION | |
IP | 40 |
PHYSICAL OVERVIEW | |
Dimensions | 26.6 x 10.3 x 30.0 cm (10.47” x 4.05” x 11.81”) |
Weight | 5.2 Kg (11.46 lb) |
Review K-ARRAY TURTLE-KRM33
Chưa có đánh giá nào.